Life-fitness 8235 User Manual

8235 LEG EXTENSION/LEG CURLPart # 6869701Revision:2/21/001ASSEMBLY INSTRUCTIONS

100123 4 561/2 1/2 1/2 1/2 1/2 1/2FIGURE 12STEP 12:STEP 11:FIGURE 11• Snap two WEIGHT PLATE BUSHINGS (25) into thetop of all twenty WEIGHT PLATES (

FIGURE 1411STEP 14:• SECURELY assemble two 4-1/2” PULLEYS (21) to the TOWER BRACE (10) using two 3/8 X 2” BOLTS (37), and two 3/8”LOCK NUTS (44).

0123 4 561/2 1/2 1/2 1/2 1/2 1/212FIGURE 15• Place TOWER BRACE (10) over the GUIDE RODS (5) and SECURELY assemble TOWER BRACE (10) to TOWER (1) usi

13FIGURE 18STEP 18:• Attach the to the KEYHOLE CLEVIS(17) to the CABLE (23) asshown in FIGURE 18.FIGURE 17STEP 17:• SECURELY assemble three

140123 4 561/2 1/2 1/2 1/2 1/2 1/2FIGURE 19STEP 19:• Assemble the KEYHOLE CLEVIS (17) to the tab on the cam of the LEG PEDESTAL (9) using one CLEV

FIGURE 2015STEP 20:• Screw the treaded end of the CABLE (23) approximately 3/4” into the end of the WEIGHT STACK SHAFT (19) and tighten jamnut secu

IMPORTANT NOTESPlease note:Tools Required for Assembly* Thank you for purchasing the LIFE FITNESS 8235 LEG EXTENSION/LEG CURL. Please readthese instru

3PARTS LISTPART #6793303666230366622036764901678230167705026777403678070368672036781303669830366255026693502678040167802016791102642710167766016284501

STEP 1:FIGURE 1• LOOSELY assemble LOWER CROSS SUPPORT (8) to the TOWER (1) using two 1/2 X 4” BOLTS (33), two 1/2” WASHERS (40)and one 1/2” LOCK N

STEP 2:FIGURE 2• LOOSELY assemble BENCH FRAME (7) to the LOWER CROSS SUPPORT (8) using two 1/2 X 4” BOLTS (33), two 1/2”WASHERS (40) and two 1/2” LO

STEP 3:FIGURE 36STEP 4:• SECURELY assemble the LEFT (2) and RIGHT (3) LEG EXT. HANDLES to the BENCH FRAME (7) using two 3/8 X 3-1/4”BOLTS (35), fou

STEP 5:FIGURE 57STEP 6:FIGURE 6• SECURELY assemble SEAT PAD (15) to HINGE TABS (45) using two 3/8 X 1-1/4” BOLTS (38) and two 3/8” WASHERS (41).See

FIGURE 78STEP 7:FIGURE 8• SECURELY assemble BACK PAD (14) to the RIGHT & LEFT PAD SUPPORTS (12) (13) using four 3/8 X 3” BOLTS (36) andfour 3/

STEP 10:9• SECURELY assemble two 3/8” SPRING PINS (47) to the PAD SLEEVES (6) as shown in FIGURE 10. (NOTE: IMPORTANT! TightenSPRING PIN complete