Life-fitness 8105 User Manual

Part # 6787901 Revision: 06/18/981ASSEMBLY INSTRUCTIONS8105 SMITH PRESS

100123 4 561/2 1/2 1/2 1/2 1/2 1/2FIGURE 8STEP 8:• Insert two 80” GUIDE RODS (13) through the BUSHINGS in the UPPER SUPPORT (11) and out through t

11STEP 9:• Slide one 1-1/2” THRUST BEARING (25), one RIGHT SAFETY HOOK (6), and one 1” SHAFT COLLAR (24) over theSAFETY STOP (2) as shown in FIGUR

12STEP 12:FIGURE 11FIGURE 12• Slide one BEARING HOUSING (1), one 2” SHAFT COLLAR (23), and one 2-1/2” OD RUBBER BUMPER (29) over eachSLEEVE ASSEMBL

13FIGURE 13STEP 13:• Lift up each GUIDE ROD (13) and insert them through each BEARING HOUSING (1) on the SMITH BAR ASSEMBLY (7)then seat GUIDE RO

14FIGURE 14STEP 14:• Lift up on each GUIDE ROD (13) and slide the RIGHT & LEFT BAR STOP ASSEMBLIES (8) over the bottom of eachGUIDE ROD (13) on

15FIGURE 15STEP 15:• Loosen each 1” SHAFT COLLAR (24) and slide each one up firmly against the BUSHINGS of the UPPER SUPPORT (11).See FIGURE 15.•

160123 4 561/2 1/2 1/2 1/2 1/2 1/2FIGURE 16STEP 16:• SECURELY assemble threaded end of CABLE ASSEMBLIES (26) into the BEARING HOUSINGS (1) using on

17FIGURE 17STEP 17:• MAKE SURE ALL CONNECTIONS ARE TIGHT!Thank you for purchasing the Life Fitness 8105 SMITH PRESS. If unsure of proper use of eq

2IMPORTANT NOTESPlease note:Tools Required for Assembly* Thank you for purchasing the LIFE FITNESS 8105 SMITH PRESS. Please read these instructionstho

PARTS LISTPART #671200267114026711203670890167116016711701671020167101026710503671040367873016709001670990167096036675501KEY123456789101112131415QTY22

• CAREFULLY lower one COUNTER WEIGHT (14) down into the LEFT UPRIGHT (9) & RIGHT UPRIGHT (10) until it bottomsout as shown in FIGURE 2.4FIGURE

5FIGURE 3STEP 3:• LOOSELY assemble the LOWER SUPPORT (3) and two PLATE HOLDER (15) to the LEFT & RIGHT UPRIGHTS (9& 10)using four 1/2 X 4-

6FIGURE 4• SECURELY assemble four PLATE HOLDERS (15) to the LEFT & RIGHT UPRIGHTS (9 & 10) using eight 1/2 X 4” BOLTS(17), eight 1/2” WAS

7STEP 5:• LOOSELY assemble two CHROME ANGLES (12) to the top of the LEFT & RIGHT UPRIGHTS (9 & 10) using four 1/2 X 4-1/2” BOLTS (16), and

8FIGURE 6STEP 6:• LOOSELY assemble UPPER SUPPORT (11) to the LEFT & RIGHT UPRIGHTS (9 & 10) using two 1/2 X 4” BOLTS (17)two 1/2” WASHERS

9FIGURE 7STEP 7:• SECURELY assemble the 4-1/2” PULLEYS (27) to the UPPER SUPPORT (11) using two 3/8 X 2” BOLTS (18) and two 3/8”LOCK NUTS (22) as s