Life-fitness G3 User Manual download pdf (Page 22)

TEP 13:

• Securely assemble the ball end of the LEG CABLE (30) and one 3-1/2" PULLEY (37) to the LEG

PEDESTAL (8), using one 3/8 x 3-3/4" BOLT (57), two 3/8 x 1-1/16" FLANGE SPACERS (49),

and one 3/8" SILVER LOCK NUT (63).

• Securely assemble one 3-1/2" PULLEY (37) to the FRONT BASE (1), using one 3/8 x 3" CLEAR

ZINC BOLT (67), two 3/8 x 3/4" FLANGE SPACERS (48) and one 3/8" BLACK LOCK NUT (78).

NOTE: The LEG CABLE (30) must be routed over the retaining bolt as shown in Figure 13.

• Carefully slide the GUIDE CABLES (65) through the GUIDE BRACKET (42) as shown in Figure

13 (B).

• Reassemble the ends of the GUIDE CABLES (65) as shown in Figure 13 (B) by attaching the

Short Cables and Turnbuckles that were removed in Step 11 (D).

• Assemble one 3-1/2" PULLEY (37) to the BASE PLATES (11), using one 3/8 x 4-1/4" SILVER

BOLT (68), two 3/8" FLAT WASHERS (64), two GUIDE CABLES (65), two 3/8 x 1" SPACERS (51)

and one 3/8" SILVER LOCK NUT (63).

NOTE: Loop the LEG CABLE (30) around the 3-1/2" PULLEY (37) before attaching it to the BASE

PLATES (11), as shown in Figure 13.

• Adjust the Turnbuckle on each GUIDE CABLE (65) to add tension to the GUIDE CABLES (65)

until they are taut. Secure Turnbuckle with the Jam Nuts as seen in Figure 13 (B).

3/8 X 3-3/4” 57

3/8 X 4-1/4” 68

3/8 X 3”

SHORT CABLE

(B)

TURN BUCKLE

FIGURE 13

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

No comments

Life-fitness G3 User Manual Page 22