LFADJ ADJUSTABLE BENCH USER GUIDEWARNING:Read and follow all directions for each step to insure proper assembly of this product.CLASS H (Consumer Use
10STEP 5: Insert two 1/2” x 1/2” BUSHINGS (20) into the top ends of the SEAT ADJUSTMENT ASSEMBLY (12). Insert the 1/2”x 6” SLOTTED SHAFT (25) through
11STEP 6: Insert two 1/2” x 1/2” BUSHINGS (20) into the bottom ends of the SEAT ADJUSTMENT ASSEMBLY (12). Insert the1/2” x 3 1/4” SHAFT (21) through
12STEP 7: Insert two 3/4” x 1” BUSHINGS (36) to the ends of the PAD HOLDER ASSEMBLY (4). Insert the 1/2” x 3 1/4” SHAFT(35) through the 3/4” x 1” BUS
13STEP 8: Insert two 3/4” x 1” BUSHINGS (36) to the of the PAD HOLDER ASSEMBLY (4). Insert one 1/2” x 5.29” SHAFT (35)through the 3/4” x 1” BUSHINGS
14STEP 9: Attach the BACK PAD (7) to the PAD HOLDER ASSEMBLY (4) as shown using two M10 x 35mm SCREWS (24) andtwo FLAT 3/8” WASHERS (19). Tighten the
15MAINTENANCEPlease note:* We recommend cleaning your product (pads and frame) on a regular basis, usingwarm soapy water. Touch-up paint can be purcha
16LIMITED WARRANTYLife Fitness® LFADJ-002 BENCHLife Fitness extends the following LIMITED WARRANTY to the original owner (proof of purchase required,
LIFE FITNESS5100 NORTH RIVER ROAD.SCHILLER PARK, IL 60176 U.S.A.Tel: 1.847.288.3300 Fax: 1.800.216.88931.800.351.3737 (Toll-free within the U.S. an
2TABLE OF CONTENTSSafety Statement . . . . . . . . . . . . . . . .2 Assembly Instructions . . . . . . . . . . . . . .6Bench Dimensions. . . . . . . .
3BENCH DIMENSIONS Height:Flat 18 inches (457mm)Fully Upright 42 3/8 inches (1076mm)Width: 21 inches (530mm)Length: 52.5 inches (1335mm)Bench Weight: 7
4COMPONENTS LISTITEM NO. QTY. PART NO. DESCRIPTION1 1 6351401 MAIN FRAME ASSEMBLY2 1 8289401 SEAT ADJUSTMENT HANDLE3 3 7646301 ROLLER 4 1 8351301 PAD
5HARDWARE:Centimeters
6STEP 1: Assemble the UPRIGHT TUBE (16) to the MAIN FRAME ASSEMBLY (1) using two M8 x 55mm HEX SOCKETSCREWS (31), four 5/16” FLAT WASHERS (37), and t
7STEP 2: Insert the COMPRESSION SPRING (33) and SEAT ADJUSTMENT PIN (32) into the ROLLER CARRIAGE (14). With the SEAT ADJUSTMENT HANDLE (2) oriente
8STEP 3: Assemble one ROLLER (3) to the bottom of the ROLLER CARRIAGE (14) using one M10 X 110mm SCREW (17),two FLAT 3/8” WASHERS (19), and one M10 H
9STEP 4: WIth the ROLLER CARRIAGE ASSEMBLY (D) oriented on its side, carefully position the ROLLER CARRIAGEASSEMBLY (D) over the MAIN FRAME ASSEMBLY
Comments to this Manuals