Life-fitness 889 User Manual

1889 WEIGHT STACK OPTIONCLASS HPART # 7347201REV. BRevision: 12/19/02USER’S GUIDEWARNING:Read and follow all directionsfor each step to insure propera

STEP 9:FIGURE 91031• Place one 3-1/2” PULLEY (9) into the loop of the CABLE (12) below the second and third PULLEY of the TOP BOOM (4) as shownin F

11STEP 10:FIGURE 10• Route the threaded end of the 123-1/4” CABLE (11) through the slot of the UPRIGHT (1) then SECURELY assemble one 4-1/2” PUL

12STEP 11:FIGURE 11• Loop the 123-1/4” CABLE (11) around one 3-1/2” PULLEY (9) as shown in FIGURE 11.• LOOSELY assemble the 3-1/2” PULLEY (9) to

13STEP 12:FIGURE 12Thank you for purchasing the Parabody 889 WEIGHT STACK OPTION. If unsure of proper use of equip-ment, call your local Parabody dist

MAINTENANCEMODEL #________________________SERIAL #_________________________DATE OF PURCHASE: _____________DEALERS NAME: _________________DEALERS PHONE

15NOTES:LIMITED WARRANTYParaBody extends the following LIMITED WARRANTY to the original owner of the ParaBody products. The Warranty terms apply to IN

INTERNATIONAL OFFICESLife FitnessAtlantic BVAtlantic HeadquartersBijdorpplein 25-312992 LB BarendrechtThe NetherlandsPhone: (180) 646 666Fax: (180) 6

THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OFEQUIPMENT. TO MINIMIZE RISK FOLLOW THESE RULES!1. Before using, read all the warnings and

IMPORTANT NOTESPlease note:Tools Required for Assembly* Thank you for purchasing the ParaBody 889 Weight Stack Option. Please read these instructio

4PARTS LISTPART #LEA6814309LEA6800610LEA6814009LEA6813709LEA6801110LEA6816501LEA6274410LEA6725310LEA3116201LEA3116101LEA7406601LEA6671002LEA6692601LEA

STEP 2:FIGURE 2• Insert two 2” END CAP (16) into the ends of the STACK BASE (3) as shown in FIGURE 2.• Attach four 3/4 X 1-1/2” GLIDES (24) to the

6FIGURE 4STEP 4:• SECURELY assemble the STACK BASE (3) and the UPRIGHT (1) to the LOWER CROSS SUPPORT using two 3/8 X 4” BOLTS (38),four 3/8” WASH

701234561/2 1/2 1/2 1/2 1/2 1/2FIGURE 5STEP 5:• Insert two GUIDE RODS (6) into the STACKBASE (3) as shown in FIGURE 5. Lubricatethe GUIDE RODS (6)

8STEP 6:FIGURE 6• LOOSELY assemble the TOP BOOM (4) to the UPPER CROSS SUPPORT using two 3/8 X 4” BOLTS (38), four 3/8” WASHERS (30)and two 3/8” LO

9012341/2 1/2 1/2 1/2STEP 8:FIGURE 8• Route the 115-3/4” CABLE (12) through the TOP BOOM (4) as shown in FIGURE 8. (NOTE: It may be necessary to r