Life Fitness Pro 2 Series User Manual download pdf (Page 7)

2. GENERAL SPECIFICATIONS

1. Frame Construction

• Frame is constructed of mechanical quality steel purchased in mill run quantities

• Frame is primarily 4” x 2” (10 cm x 5 cm) and 3” x 2” (8 cm x 5 cm) rectangular-shaped

tubing with 11 gauge wall thickness.

• Frames are mostly fully welded and constructed in two, but not mores than 3 pieces to

facilitate movement through smaller doorways and difficult installations

2. Frame Finish

• Prior to applying finish, each part is chemically washed to prepare surface for maximum

adhesion.

• The frames are coated with an electrostatic epoxy powder coat finish applied in a powder

form and then baked at 400° F (204° C.)

• To prevent frame and surface corrosion, wax equipment annually and keep away from salt,

chlorine and all other harmful chemicals.

3. Weight Selection

• Weights are selected by using a 7/16” selector pin, which completely penetrates the weight

plate and is held in place during use by a magnetic ring to keep the pin from disengaging

during use.

• The selector pin is connected to the top weight to eliminate loss or substitution of

substandard pins.

4. Incremental Weight System

• Incremental weight system allows the resistance to be increased in 5 pound increments and

are contained on the guide rods to eliminate removal.

• When in use, the increment weights retain the balance of the stack resulting in a smoother

action of the weight stack as compared to systems which load the increment on the side or

back of the actual stack.

5. Weight Plates

• Machined from solid, 1” thick steel. Finish is wrinkle gray powder coat. Thickness of plate is

held to precise tolerances by machining the entire upper and lower surfaces resulting in a

better pin fit to the stem.

6. Weight Plate Bushings

• Each plate (not just the top weight) will contain low friction bushings, which surround the

guide rods to minimize friction and noise

7. Top Weight Bushings

• The top weight runs on bushings which are mounted in the plate with rubber gromments to

compensate for minor misalignment and insure optimal performance.

• The bushings are self-lubricating in order that the guide rods will not require lubrication.

2-1

1 2 3 4 5 6 7 8 9 10 11 12 ... 42 43

No comments

Life Fitness Pro 2 Series User Manual Page 7