Life-fitness Pro Series User Manual download pdf (Page 60)

4. Maintenance Procedures

4-2

ONCE A DAY

• Wipe down upholstery with a mild soap and water or comparable all purpose cleaner.

• Visually inspect all cables for wear at and around connections and along entire length of cable.

Always replace at first sign of wear.

ONCE A WEEK

• Visually inspect all hardware for loosening, tampering or wear.

• Check jam nut on weight stack for tightness.

• Inspect all accessory and or carabiner clips or connecting links for wear.

• Check condition of hand grips.

• Check cables for stretch and adjust as necessary by loosening the large nut on top of the weight

stack and screw in the threaded plug until cable is tight and the weight pin goes in all holes easily.

Tighten the large nut to complete the adjustment.

ONCE A MONTH

• Clean Guide Rods with paint thinner on a cloth and wipe off old residue. Clean tops of bearings at

stack and inspect for heavy buildup on rods below headplate (lift half of stack and do a visual

inspection, then clean as necessary).

LUBRICATION

• Clean and lubricate all stainless steel slides as necessary.

• Lubricate linear bearings with TF1000 grease (part number SK50-P0004-0000).

• Lubricate guide rods with Break-Free (part number SK50-P0005-0000). Apply the Break-Free to a

cotton cloth, then run the cotton cloth up and down the guide rods as needed.

• Range limiting device should be cleaned and lightly oiled using Break-Free.

NOTES

• Use polishing compound (such as car wax) to clean and remove shoe scuffs from powdercoated

surfaces as necessary.

1 2 ... 55 56 57 58 59 60 61

No comments

Life-fitness Pro Series User Manual Page 60